Golf Driver Senior Flex Categories
It should essentially be within 7.5 degrees to 13 degrees. The angle decides on how well you get the ball high into the air. If you are an amateur go for a lower value if not go for the higher angle. As far as the shaft length factor the longer the shaft the more is the speed. So you could opt for lengths between 43-46 inches. As far as the material of the shaft is concerned you have a plethora of steel graphite and other materials available. For the modern times graphite should suit your putting needs. Lastly you need to finalize on the grip size which should essentially be smaller because larger grips reduces the swing of the club.
For the back swing your hips should only turn back slightly. Do not sway shift or tilt backwards with your hips but rather keep your foundation stable and rotate from the base of your spine. When you enter the downswing youll need to rotate (not shift) your hips forward to make room for your swing and the golf club to come through. With a little practice it should not be hard to keep your balance throughout your golf driver swing. The key to hitting your driver well is the same as hitting any club well you need to have a good golf swing. If youre not confident in your ability to swing the golf club well then you should enroll in some online golf swing lessons. They are extremely inexpensive and in many cases the teachers are better than your local golf pro.
Kinds of drivers There are three golf driver types according to the material that they are made of: the alloy drivers stainless steel and forged titanium. Alloy golf drivers have shafts made of stainless steel or graphite and Ti Alloy heads. They are great for driving the ball into the first course. Stainless steel drivers on the other hand come with hard and strong heads and are the most common choices among the golf driver types. They have compact heads and are heavier than the alloy and titanium varieties. Finally there are the forged titanium drivers. These golf drivers are composed of titanium heads and shafts that are made of lightweight graphite.